JP MICROTECH

Expert reports

Three research institutes have assessed the process. These are their key statements.

Fraunhofer ENAS 600

Fraunhofer Institute for Electronic Nano Systems ENAS

Chemnitz and Paderborn Tobias Seifert, Frank Roscher

The number of applications in which printing processes are used for electrical contacting is increasing constantly. There are several reasons for this:

  • In recent years, the quality of printable materials has been significantly improved.
  • The variety of materials has been considerably increased.
  • The reliability has been substantially improved.

Conclusion: In future, a steady growth of printing processes in the production of electronic systems can be expected. Digital printing processes such as the aerosol jet printing process can be used in the field of packaging as a substitute for wire bonding processes (e.g. for standard MMIC components).

In particular, digital design aspects and fast implementation possibilities for prototypes benefit from this process.

In general, the application of printed RDLs according to the current state of technology is not only expected to have application potential in the prototyping area or low-performance area. Series production is also conceivable for each product class with a fully qualified and optimised process chain including a service life analysis.

tu dresden 600

Dresden University of Technology

Faculty of Electrical Engineering and Information Technology Professor Dr Ing. habil. Jens Lienig, Dr Ing. Frank Reifegerste

The technology report on the process “Aerosol Jet Printing for heterogeneous 3D integration in semiconductor modules” summarises the advantages as follows:

  • The integration of different elements in one package is a unique selling point.
  • For the first time, the integration of sensors, MEMS, chemical components (lab on chip), micro actuators, photonic components (radiation, colour, light sensors, solar cells, LED, laser), other semiconductors (III/IV semiconductors, SiC, SiGe) as well as RF components (waveguides, antennas) has become possible.
  • In medical technology, aerosol jet printing can be used to produce components in a highly miniaturised device system.
  • IoT - heterogeneous 3D integration using aerosol jet printing can demonstrate its advantages in sensor networks in environmental measurement technology (water and air quality, heating, ventilation, lighting controls, greenhouse controls), applications in the energy industry (condition monitoring of wind turbines and overhead lines) or in building monitoring (measurement of moisture, strain, temperature).
  • In the consumer sector, possible applications are conceivable, for example, in the measurement of bodily functions in athletes.
fraunhofer ifam 600

Fraunhofer Institute for Manufacturing Technology and Applied Material Research

Bremen Timo Rusch, Dr. Ingo Wirth

The report of the Fraunhofer Institute on the Aerosol Jet® Printing process for use in semiconductor manufacturing comes to the following conclusion:

  • Although Aerosol Jet® Printing has already been used in many areas, this process has hardly been used in the field of manufacturing in the semiconductor industry so far, despite many advantages - established lithographic processes are still relied upon.
  • While the lithographic process is a high-volume process, the Aerosol Jet® process, as a CAD-supported additive manufacturing process, offers the greatest possible flexibility and significant economic advantages as well as a lower process cost compared to the lithographic process.
  • The material waste associated with conventional subtractive processes can be avoided by using the Aerosol Jet® process. As material is only applied to the previously determined areas, the process is resource-efficient and sustainable (Hedges, 2005).

Advantages:

  • Aerosol Jet® Printing can be used to coat wafers and other planar, curved or complexly shaped surfaces with a resolution of up to 10 μm.
  • Small structures in particular can be applied quickly and economically without masks.
  • The printing process offers great advantages for multilayer structures, for example in the production of interposer layers.